BEE (BUES-FYP): Recent submissions

  • Talha Bin Tahir, 01-133132-247; Usama Malik, 01-133132-259; Zeeshan Ahmed Abbasi, 01-133132-250 (Electrical Engineering, Bahria University Engineering School Islamabad, 2017)
    In power circulation system it is fundamental to limit faults, voltage line dips and spikes that occur because of fault. As it happens in power framework, the fundamental strides will be taken to evacuate the fault utilizing ...
  • Waqas Nasir, 01-133092-101; Muneeb Akbar, 01-133092-065 (Electrical Engineering, Bahria University Engineering School Islamabad, 2013)
    This report is a documentation of the FYP we opted for as a requirement of our degree. The FYP is, as the name suggests, a robot. This robot was designed in lieu of the need of the industry for an efficient problem diagnosing ...
  • Hajra Aziz, 01-133092-026; Sumbal Khalid, 01-133092-086 (Electrical Engineering, Bahria University Engineering School Islamabad, 2013)
    Introduction literature review problem statement project design design verification Conclusion
  • Kashif Raza Ansari; Iqra Wiqar (Electrical Engineering, Bahria University Engineering School Islamabad, 2013)
    ***Attached***
  • Waleed Ahmad (Electrical Engineering, Bahria University Engineering School Islamabad, 2013)
    The world today has all the possible resources but time. People have gone so far as to declare time as money, when nobody knows exactly what time is. All that the humankind has achieved is the ability to measure time. Thus, ...
  • Syed Nigah-e-Ali Naqvi, 01-133112-084; Muhammad Shahzad Gul, 01-133112-052; Muhammad Hammad, 01-133112-033 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    Efficient monitoring and management of vehicles is a complex task and hard to do manually. There is a lot of problem and challenges of management and performance optimization. Nowadays, most of the cars have electronic ...
  • Junaid Maqsood, 01-133112-031; Mirza Qutab Baig, 01-133112-025; Syed Murtaza Ali Shah Bukhari, 01-133112-083 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    Renewable energy based power systems are one of the emerging technologies in modern era especially the solar energy. As the electric power consumption is increasing day by day, there is a need to look at the resources and ...
  • Ahrar Ali Tahir, 01-133102-011; Zeerak Khan, 01-133102-104; Arif Hussain, 01-133102-018 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    The rising number of terrorist attacks all around the world have given rise to a global demand for effective security mechanisms. The systems currently in use have repeatedly failed in the face of attacks and as a result ...
  • Musharaf Chaudhary, 01-133112-067; M. Yaqoob Harral, 01-133112-059; M. Faiq Khan, 01-133112-042 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    Object tracking is a process of locating a moving object over time using a camera. Tracking is usually performed in the context of higher-level applications that require the location and/or shape of the object in every ...
  • Ehtisham Masood, 01-133112-013; M.Aqib Zaheer, 01-133112-035; M.Armaghan Ahsan, 01-133112-036 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    The idea behind the project title is to develop GSM based control system. That is to start/stop and remote monitoring of the motor. Our outcome is a control system which allows the user to effectively monitor and control ...
  • Muhammad Maaz Ahsan, 01-133112-046; Faheem Akhtar, 01-133112-210; Muhammad Suleman, 01-133112-054; Ali Raza, 01-133112-008 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    Range of RF system depends upon output power of transmitter, sensitivity of receiver and high gain antennas. Long Range Signal Amplifier transmits message signal at 2.4GHz ISM band and receives at distance of 1km. Yagi-Uda ...
  • Rehan Anwar, 01-133112-072 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    The joystick based control mechanism provides a dynamic control for a differential drive robot. Project’s novelty lies in the achievement of a full 360-degree of freedom in movement. This robot is featured to be used ...
  • Ihsan Farooq, 01-133102-037; Usman Rauf, 01-133102-095; M. Abubakar Qureshi, 01-133102-045 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    Power Transformer is an electrical device which transfers energy between two circuits through Electromagnetic Induction. Power transformers are the most important and expensive equipment in any power supply system. Keeping ...
  • Muhammad Azeem Afzal, 01-133102-052; Wafa Arshad, 01-133102-102; Alyan Perveiz, 01-133102-014 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    The UGV’s which we had seen in past could not be moved autonomously and to control them people would use remote controlled modules and big joysticks. It is difficult to use and carry big sized modules especially in battle ...
  • Yusra Mahmood, 01-133112-200 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    Radio frequency identification (RFID) is the most versatile emerging technology which has greatly revolutionized our lives in the area of ubiquitous systems.RFID is the replacement of barcodes. RFID system requires no ...
  • Aqib Rafique, 01-133112-201 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    The recent development of Graphene based Nano antennas, Carbon Nano Tubes (CNTs) and Graphene Nano Ribbons (GNRs) have opened up a new pathway for the Electromagnetic communication. Modern microprocessor architecture design ...
  • Muhammad Suhail, 01-133102-247; Noor Aziz, 01-133102-071; Muhammad Amjad, 01-133102-049 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    The project is about product measurement and quantitative analysis unit. It performs these two functions; it measures the length of an industrial product (piece of glass slabs, piece of an iron sheet or pipe etc.) and ...
  • Arslan Naseer, 01-133102-020; Muhammad Umair Latif, 01-133102-063 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    Generators are versatile source of electric power. Generators have numerous applications in many industries and that is why they are considered very pivotal devices. The optimal performance of the generator depends on its ...
  • Muhammad Bilal, 01-133112-038; Haroon Akbar, 01-133112-021 (Electrical Engineering, Bahria University Engineering School Islamabad, 2015)
    The technology for solar battery charge controllers has undergone great advancements in the past few seasons. The most emerging new technology isPWM algorithmic charging technique, which gained popularity increasingly.Charging ...
  • Laraib Aamer, 01-133102-039 (Electrical Engineering, Bahria University Engineering School Islamabad, 2014)
    Telecom industry is amongst the biggest industries. We cannot afford any outage of power especially in a country where energy crisis is a big problem. BTS power monitoring and alarm system is a system which will monitor ...

Search DSpace


Advanced Search

Browse

My Account